Product range

Dairy Processing Equipment

Pasteurisers, separators, homogenisers, fermentation tanks and fillers, chosen as a sequence rather than a catalogue.

Pasteurising to packing

Heating, separating, homogenising, fermenting and filling, in the order the process runs.

Batch or continuous

Vats for batch work, inline units where the line runs without stopping.

Holding time held

Temperature and hold controlled inside the band the product needs.

Cleaned between runs

Contact surfaces, drain points and access laid out for daily cleaning.

11 machines in this range

Shown in full

01Mixing & Emulsifying

Vacuum Emulsifying Mixer

A three-layer jacketed tank holding vacuum while a bottom homogenizing head shears the batch, from 300 to 5000 L and up to 100,000 cps. Air comes out as the emulsion forms, so mayonnaise and face cream stop separating and stop foaming at the filler.

Tank volumes
300 / 500 / 5000 L, working charge below nominal
Viscosity
0 to 100,000 cps, anchor paddle with wall scrapers
Speed
0 to 3000 rpm, homogenizer and agitator on separate drives
View machine

02Mixing & Emulsifying

High Shear Homogenizer

A lifting dispersing head over a mobile covered vessel, 50 to 500 L per batch at 2880 r/min with inverter control. Change product by changing the drum, so a lab trial and a mid-volume run share one machine instead of two.

Batch size
50 / 100 / 200 / 300 / 500 L, five ratings
Drive
Copper-winding motor 2.2 to 7.5 kW, 2880 r/min with VFD
Lift
Electric or pneumatic, 400 to 600 mm stroke
View machine

03Mixing & Emulsifying

High-Pressure Homogenizer

A three-plunger reciprocating pump pushing product through a homogenizing valve at 20 MPa working pressure and a 25 MPa rating, at 100 to 2000 L/h. Fat globules go from 3 to 4 microns down below one, so milk stops throwing a cream line and yogurt stops turning gritty.

Series
GD-XMHG01, eight flow ratings from 100 to 2000 L/h
Pressure
20 MPa working, 25 MPa rated, two-stage mechanical setting
Fineness
Emulsion average below 1 micron, solid dispersion below 2 microns
View machine

04Cheese Making Equipment

Cheese Processing Production Line

Ten stations from raw milk receiving to pressing on a 4 t/day baseline, with the buffers sized at the design stage so no station waits on the one before it. Mozzarella, cheddar and fresh soft cheese run on the same line; changing variety is mostly a change of recipe and mould, not of equipment.

Capacity
4 t/day baseline, batch size 100–5000 L (500 L reference)
Stations
Ten — receiving, cooling, duplex filter, pre-heat, homogeniser, pasteuriser, fermentation, cheese vat, whey cart, press
Installed power
Approx. 100 kW, 380 V or 440 V, 50–60 Hz
View machine

05Cheese Making Equipment

Cheese Cutting Machine

Wire-grid cutting that turns a cheese block into cubes or strips in one or two passes, on a single lane or two, with the mould setting the size. A mould change is the whole size change, and the cut faces stay clean — no crumbs, no hidden give-away where a knife dragged through the block.

Models
GD-SCCM-I single lane 7 kW; GD-SCCM-II dual lane 7.5 kW
Cutting
Two-pass forming on the single unit, one-pass with both tools on the dual
Shapes
Cubes, sticks and slices; size set by the mould, not by the operator
View machine

06Cheese Making Equipment

Cheese Making Machine

A jacketed cheese vat from 100 to 1000 L in five models that carries pasteurising, culturing, coagulation, curd cutting and cooling through in the same vessel, held at ±1 °C. Because one vessel does all five steps, a batch no longer depends on how fast someone can work an open vat by hand.

Batch capacity
100–1000 L, five models in the GD-GCCM series
Function
Pasteurising, fermenting, coagulation, curd cutting, cooling
Accuracy
±1 °C fermentation control, VFD agitation 0–36 rpm
View machine

07Milk & Yogurt Processing

Dairy Cream Separator

Disc stack centrifuge with 400 to 3000 L per hour of milk output across four models, taking cream and skim milk out of two outlets continuously instead of waiting on gravity in a settling tank. Bowl speed runs from 5980 to 8300 rpm depending on the model, and the sludge discharge is automatic except on the smallest unit.

Milk output
400–3000 L/h across four models
Bowl speed
5980–8300 rpm, bowl diameter 230–400 mm
Discharge
Automatic sludge discharge; manual on GD-CS203
View machine

08Milk & Yogurt Processing

Vacuum Degasser

Continuous in-line deaeration at 500 to 1500 L per hour and -0.07 to -0.08 MPa, where the product is spread into a thin film inside the vacuum tank so dissolved and entrained air leaves in one pass. Filling then runs without foam, and the colour and vitamin loss that shows up weeks later on the shelf does not happen.

Capacity
500, 1000 or 1500 L/h, three standard models
Working vacuum
-0.07 to -0.08 MPa, water ring vacuum pump
Power
5.37 kW total, 380 V three phase
View machine

09Milk & Yogurt Processing

Mixing Tank

Jacketed stainless mixing tank from 50 L to 5000 L in nine sizes, with the impeller and the homogeniser matched to the viscosity of the product rather than sold as one universal head. Wall scrapers keep the film off the jacket surface, which is what stops the burnt bottom and the thin tail at discharge.

Capacity
50–5000 L working volume, nine standard models
Agitation
0–63 r/min anchor or paddle; homogeniser 0–3000 r/min
Heating
9–96 kW electric elements in the jacket, by model
View machine

10Milk & Yogurt Processing

Fermentation Tank

Three-layer jacketed fermentation tank from 100 L to 1000 L in six models, held on PLC temperature control and vented through a sterile breather with a filter element. The vessel stays closed from inoculation to discharge, so a batch sets to the same acidity and texture whether or not an experienced hand is on shift.

Capacity
100–1000 L working volume, six standard models
Temperature
45–90 °C adjustable, PLC control with live display
Body
Three layers — inner vessel, circulation jacket, insulation
View machine

11Milk & Yogurt Processing

Milk Pasteurizer Machine

Batch water-bath pasteurizer with mechanical agitation and a water-cooling circuit. Six sizes from 10 L to 200 L, temperature adjustable to 99 °C, holding time programmable. Built for milk bars, farm shops and small dairy rooms where milk has to keep for days, not hours.

Capacity
10–200 L per batch, six models
Heating
Indirect water bath, electric (steam or gas on request)
Temperature
Ambient to 99 °C, programmable holding time
View machine

About this range

Milk leaves the farm as a perishable raw material and only becomes a product after heat treatment, separation, homogenization and fermentation. Each of those steps changes what the next machine can accept, so the equipment has to be chosen as a sequence, not as a shopping list.The range below covers the processing side of that sequence, from a 10 L batch pasteurizer on a farm counter to a 5,000 L mixing and emulsifying system in a plant. If you are not sure where to start, send us your daily volume and finished product and we will point you to the right entry point.

WhatsApp Email
Process first, machine second — pick the product you make. All applications ›
Dairy processing tanks and plate heat exchangers installed in a production hall
Bottling line installed in a factory hall, bottles moving through the filler

Turnkey Production Lines

A complete line is more than a row of machines. We size the filler, the sealing station and the conveyor runs against your product, pack format and shift target, then deliver it as one commissioned unit.

Complete powder filling line running in a factory hall